Seawall replacement and new seawalls

When replacement makes sense

Replacement is the answer when panels are cracked through, the wall leans, repairs would cost more than half of a new wall, or the wall is too low for your city's new standard.

• Panels cracked through or leaning
• Repeated sinkholes despite repairs
• A city notice to raise or rebuild
• Planned dock or lift work that needs a sound wall

What a seawall replacement involves

A Florida engineer designs the wall to the site's soil, water depth and the local top elevation. Most replacements go in front of the old wall, which stays in place as backing, because removing it can undermine the yard.

1. Survey and engineered drawings
2. DERM, city and state approvals
3. Turbidity barrier and manatee watch in the water
4. New panels or sheet piles, tiebacks and cap
5. Backfill, drainage and yard restoration

How far out can the new wall go?

Florida Statute 403.813 exempts restoring a seawall at its previous location, upland of it, or within 18 inches waterward of it. Miami-Dade's short form and the federal SPGP VI use the same 18 inch line, measured wet face to wet face, and need no seagrass survey within it.[4][3][5]

Federal permits

Under SPGP VI, the Florida DEP could verify the federal Army Corps authorisation for qualifying seawall work along with the state decision. That permit's stated expiration date was 27 July 2026, and we have not been able to confirm a replacement, so for each job we confirm the federal route with the agencies before we file.[5][6]

Working around manatees

Permits attach the state's Standard Manatee Conditions: all in-water work stops if a manatee comes within 50 ft, and resumes only once it has moved beyond 50 ft or 30 minutes pass without it reappearing. Turbidity barriers must not entangle or block manatees.[7]

Frequently asked questions